Nokia 12 GSM MODULE REMOTE I/O Manuale Utente Scaricare il pdf (Pagina 45)

X” command. Note that all example control messages in this chapter use the

“term123” identifier string and the password property is set off (see Table 13).

The command cancels the timing of the pulse operation and informs the original

pulse originator about it. The state of the cancelled output remains the same, as

was set with Output_Pulse X command. Thus, it is the timing of the pulse

that is cancelled, not the pulse itself.

Table 13. Output_Pulse_Cancel X commands

Command Type Command

Comments

Output_Pulse_Cancel X

term123

Output_Pulse_Cancel X

Response:

OUTPUT_PULSE_CANCEL X:

Indication to original pulse originator:

OUTPUT X PULSE

CANCELLED

The X refers to output pin number,

X=1,2,3,4,5,6,7,8,9,all.

The command cancels

the pulse of output pin X

Note: When canceling a pulse, the state of the output does not revert to the same

as it was before the Output_Pulse X command. The Output_Pulse_Cancel

X command cancels the timing on the pulse, not the pulse itself, as can be seen in

Figure 10 (the pulse without cancelling can be seen dashed in the figure).

0 s 3 s 5 s Time

41/49

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 51 52 53

Nessun commento

Nokia 12 GSM MODULE REMOTE I/O Manuale Utente Pagina 45